Toyota HULUX 2020 Body Section Manual page 12

2) Rearward visibility (outside rear view mirrors)
For narrow over fenders (Single Cab) : The width of vehicle accessories should be less than 1800mm.
For wide over fenders (Extra & Double Cab) : The width of vehicle accessories should be less than 1855mm.
· Ensure good rearward visibility when mounting vehicle accessories with width other than those specified
above.
(Ex. Adjust the installation position of the mirrors outward using adapters.)
3) Extra cab (For Europe only)
Install the door edge protector moulding, which is mounted on the vehicle, to the rear end of the access
panel when either of the following conditions is applicable:
· When the width of vehicle accessories, which are to be mounted from the rear of the cab, is narrower than
the overall width of the cab
· When the height of vehicle accessories does not meet the protrusion requirements of the access panel
edges
3)-1 Door Edge Installation Instruction for Extra Cab
(For Europe only)
Install the side protector moulding set to the rear end of the access panel LH/RH (to meet protrusion
requirements).
Components of side protector moulding set (75805-0K010)
Part name
a) Moulding, door edge protector
b) Tape, moulding, No.1
1. Take the side protector moulding set (75805-0K010) out of the
rear seat floor box.
2. Using a degreaser, remove any dirt and oil from the rear outer
edge of the access panel LH where the No. 1 moulding tape will
be applied.
3. Open the side protector moulding set, and take the door edge
protection moulding (75739-0K060) and the No.1 moulding
tape (75895-0K060) out of the side protector moulding set.
4. While peeling off the white release paper, apply the No. 1 moulding tape to the access panel LH, at a
location 60mm from the lower end and approx. 2mm from the outer edge of the access panel LH.
No.1 Moulding Tape application area:
The illustration shows the left side.
【2】-2. Compliance with laws and regulations
No.1 Moulding Tape
Access Panel
Part No. Q'ty
75739-0K060 2
75895-0K060 2
- 6 -
Note
L720
t:0.4, w:7, L:720