Delta CP.0.DPS Series Operation Manual page 15

To pull a load, press up button
Uneven winding of the wire rope will cause
load to swing and in result damaging the wire
rope.
To release a load, press down button
When the weight is near the rated capacity, the user should test the brake each
DANGER
time when such load is handled. By lifting the load with a short distance. If used
for lifting purposes, please contact a professional and carry out a risk analysis.
Also any modifications made on the electric pulling winch
responsibility of the user / owner.
problems caused by modifications, wrong use, or any other abnormal situation.
Emergency procedure: In the event of a blocked steel wire or any other
DANGER
malfunction of
without attempting any further actions. Immediately set up a safety perimeter
around the winch and the load to prevent access by any unauthorized persons.
Call in the necessary personnel to remove the load and intervene on the winch.
Stop operation if there is any abnormal noise or vibrations in the gear box.
WARNING
Do not connect the with the grounding of the welding machine.
WARNING
WARNING Be sure not to operate with slackened wire rope. Always wind wire rope tightly.
WARNING Check the winch and make sure that the wire rope around the drum is even.
Be sure to fix a rope in the centre of the swivel hook
CAUTION
When wire rope become fully stacked, stop operation immediately.
WARNING
Avoid contact with obstacles, so make sure that the load / wire rope / hook does
CAUTION
not make any contact.
Always leave/store the push button control in a correct manner after use.
CAUTION
WARNING Always ensure that the load is well balanced and secured before operation.
will not be responsible for any
electric pulling winch, immediately stop the maneuverer
is the sole
15