Safe Operation; Declaration; Install And Test; Test Before Operation - Delta CP.0.DPS Series Operation Manual

230/400 volt
Table of Contents

Advertisement

4. Safe operation

4.1 Declaration

Exceeding the rated capacity of the
electric pulling winch will lead to dangerous situations.
Before operation, please read all the contents of this manual, please make sure that you understand
all items, if so then you may operate the winch. Before operating the
electric winch, please
make sure the work space, structures meet all the safety requirements. Also the capacity must be even
or higher as the rated WLL. Also adhere to any standard or rules which applies. Always use common
sense and make sure that pulling / hoisting procedure is followed closely when winches put in use.
Always keep an eye at the load and its environment.

4.2 Install and test

Put the winch into a reliable frame, and make sure that the power supply is correct, then push the pull
and release button of the pendant control, observe the winch for correct functioning.

4.3 Test before operation.

Before operation of the
winch, always test it for correct functioning without load. If it runs
normally, winch may be used with load. Always check the brake by performing a small test, where
the load is suspended (full capacity), the brake must keep the load.

4.4. Inspection

To ensure continuous and satisfied functioning of the
electric pulling winch, it must be
inspected on a regular basis. Let professionals inspect the
winch and change any broken parts
if needed, to prevent potential danger.
The inspection interval is determined by the usage and must be done regularly. Always check the
winch and wire rope for any kind of wear, damage, rust or any other form of damage. This must be
taken seriously. Always control key parts and perform test on a regular basis. The inspection type is
separated as daily inspection and periodic inspection.
Daily inspection: Before daily use, operator should always perform a visual inspection to prevent
any surprises. This must be logged in a logbook.
Periodic Inspection: Check by a professional according to the user work situation. This must be
logged in a logbook.
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp.0.dpt series

Table of Contents