Table of Contents
Advertisement
5. Installation
5.1 Pre installation check
CAUTION
Check
Check that all fasteners and joints on the
WARNING
secure.
Always make sure that the capacity of the bottom hooks corresponds with the
WARNING
Always check and inspect the wire rope on wear, corrosion or any other type of
WARNING
damage. The wires may not be broken, If detected, please put the
winch out of use. A professional must replace the load before any further use.
Check that all external wiring is in good order.
CAUTION
WARNING
Always check the weight of load and make sure that it does not exceed the safe
working load of
Inspect the engine (chamber), it needs to be clean and dry. Also make sure that
CAUTION
the
Make sure that the winch and steel wire is free of obstructions.
CAUTION
The following environmental conditions will result to winch failures:
Low temperatures below – 10 °C
High temperatures above 40 °C
In wet conditions
5.2 Mounting holes of
The mounting plate/underground should have enough capacity to hold the
DANGER
maximum safe working load of the
recommended to include a generous safety factor. Always make sure that all
holes are used and make sure that bolts and nuts are secured tightly.
The winch is designed to be mounted on a firm or stable flat underground / plate.
electric winch for transit damage.
electric winch.
electric pulling winch.
electric winch is protected against any form of humidity.
electric pulling winch
electric winch are tight and
In organic, chemical or explosive atmospheres.
In heavy dusty conditions
electric winch. It is always
Dimensions can be found in section 3.2.3
electric
12
Advertisement
Table of Contents
