Motion Detection Setup - CONCORD QV5200 Manual

Chapter 6 Channel Setup
6.7.1 Motion Detection Set-up
To minimize the number of events that are recorded and alerted you can filter out
unwanted detections. You can do this by limiting the area of detection or reducing
the sensitivity of the motion detection.
The image covered in red squares is a live image from the camera you are editing,
anything that moves in an area covered by a red square will trigger an event. To
reduce the number of triggers you can simply change the motion detection area so it
is only covering areas that you want detected. To remove motion detection, click on a
square where you want to start, this will remove the red from that square, and drag
the cursor to clear the desired non-detection area of red squares. This area will now
not be detected. This is a useful tool if you want to mask off an area such as a
footpath or street.
If you want to reduce the chance of
an alert being triggered by a dog or
cat passing or something far away,
you can reduce the sensitivity level
in the Sensitivity drop down menu.