Advertisement
Setup Wizard
Configuring your device using the Wizard
The Start-up Wizard automatically runs the first time you power up
the NVR, however it is not necessary to run the wizard to get
started. The wizard will guide you through customising the
network , date and time setup, as well as IP camera, storage and
screen resolution configuration. You will also find the QR code to
setup the mobile app. All these settings can be changed in the
Setup menu later.
If you are happy to stick with the default settings you can cancel the
Setup Wizard by clicking
at the top right of the pop up.
Configuring Date and Time Manually
If you cancel the wizard, you will need to set up the date
and time manually by opening the menu (bottom left
corner), click Setup System General Date &
Time, change to suit your time zone.
In this menu you can setup the date and time manually
using settings under
or ticking "Enable NTP"
under
to use the Network Time Protocol
which automatically sets the time through your router.
You can also use
to set Daylight Savings
Time for your region.
6
Advertisement
