Table of Contents
Advertisement
INSTALLING THE BATTERY
Firstly, install two pcs of No. 1 batteries in the battery box at the bottom of the gas hob, and
then perform the ignition and fire size adjustment according to the order of
illustration. (illustrated in fig. 2.3)
LIGHTING THE BURNERS
To ignite the burner, the following instructions are to be
followed:
1.
Press
in
the
counter-clockwise(fig. 2.3) to the full flame position
marked by the "
until the flame has been lit.
In the case of a mains failure light the burner with a
match or lighted taper.
Wait for a few seconds after the gas burner has been
2.
lit before letting go of the knob (valve activation delay).
3.
Adjust the gas valve to the desired position.
If the burner flame should go out for some reason,the safety valve will automatically stop
the gas flow.
To re-light the burner,return the knob to the closed "
and then repeat the lighting procedure.
Note: If your local gas supply makes it difficult to light the burner with the knob set to
maximum,set the knob to minimum and repeat the operation.
corresponding
knob
" symbol (fig. 2.1) ;hold the knob in
and
turn
"position,wait for at least 1 minute
IMPORTANT:
T
check the control knobs are
the closed "
10
Battery
Battery
Fig. 2.2
Fig. 2.3
After using the burner
" position.
box
in
Advertisement
Table of Contents
