HP 9000 Manual page 87

(309) WARNING: Close not completed as data processing not complete
CAUSE: There was still data to send to the device on the remote terminal
server as the close was requested.
ACTION: No action is necessary.
(310) WARNING: Close request ignored as connection not open
CAUSE: The close request was received and ignored as the connection was not open.
This occurred because of an application sending a close request at the
wrong time or because of an error that previously closed the connection.
ACTION: Generally, no action is necessary unless a close request is not
sent after an open request.
(311) WARNING: Binary mode cannot be turned off as permanently turned on
CAUSE: The application requested that the binary mode be turned off when the
binary mode is turned on for the connection using the port configuration
file and thus cannot be turned off.
ACTION: Determine if the binary mode is necessary at all times and disable it if it is not.
(312) WARNING: Unable to perform flush operation
CAUSE: The application requested a flush operation and ocd and ocdebug do not
support that operation.
ACTION: Determine if a flush operation is necessary by the application and
do not perform it if it is not.
(313) WARNING: Cannot open port configuration file:
system error <system_error>: <system_message>
CAUSE: The open of the port configuration file failed due to the system error given.
NOTE: This message is followed by message (350).
ACTION: Verify the port configuration file name, location, and permissions.
Appendix B: ocd Logging Messages B-21