HP 9000 Manual page 79

(226) ERROR: Unable to obtain send break request argument:
system error <system_error>: <system_message>
CAUSE: The parameter for a send break control device request could not be
obtained due to the system error given.
ACTION: Determine if the correct structure (termio) is used and the correct
parameters are being set and make any changes necessary.
(227) ERROR: Unable to obtain flow control request argument:
system error <system_error>: <system_message>
CAUSE: The parameter for a flow control device request could not be
obtained due to the system error given.
ACTION: Determine if the correct structure (termio) is used and the correct
parameters are being set and make any changes necessary.
(228) ERROR: Give up trying to obtain connection as connection already established
CAUSE: A connection to the device on the remote terminal server was already established.
ACTION: Establish only one connection for each device on a remote terminal server.
(229) ERROR: DO binary negotiation rejected by remote side
CAUSE: The idea of binary mode data transfers was rejected by the remote terminal server.
NOTE: This message is followed by message (296), (297), and (299).
ACTION: Determine if binary mode can be toggled on for the terminal server
and restart the application if it can.
(230) ERROR: DONT binary negotiation rejected by remote side
CAUSE: The idea of non-binary mode data transfers was rejected by the remote
terminal server.
NOTE: This message is followed by message (296), (297), and (299).
ACTION: Determine if binary mode can be toggled off for the terminal server
and restart the application if it can.
Appendix B: ocd Logging Messages B-13