Cleaning - Silvercrest SHTP 2100 A1 Operating Instructions Manual

BB*5$B+DDUWURFNQHUB%ERRN 6HLWH  'RQQHUVWDJ  -DQXDU    
Ion function
You can use the ion switch 7 to additionally
activate the ion function, whatever setting
you are using. This then continuously applies
ions to the hair.
This reduces the static loading of the hair
and improves its stylability.
The hair becomes soft, smooth, glossy, and
easier to style.
• Ion function on, LED in switch lights
up
• Ion function off, LED in switch off
NOTE: for an optimal styling result, use the
ion function without attachments.
Styling attachment
The styling attachment 11 makes it possible
to direct the air flow onto specific sections of
hair.
1. Place the styling attachment 11 onto
the front of the hair dryer, so that it
locks into position.
2. The styling attachment 11 can be rotat-
ed into any position desired.
3. Do not remove the styling attachment 11
from the hair dryer until it has cooled
down.
Diffuser
Use the diffuser attachment 1 to create curls
and gentle waves in the lengths and tips, as
well as for body and volume at the roots of
the hair.
1. Figure A: Place the diffuser 1 onto the
hair dryer.
2. Switch on the hair dryer.
3. Use:
- For long hair: draw diffuser 1 through
to the tips, and style the hair into gentle
waves in the direction of the roots.
- For short hair: use the diffuser 1 to
work on the hair around the roots, gen-
erating body and volume.
4. Do not remove the diffuser 1 from the
hair dryer until it has cooled down.

6. Cleaning

DANGER!
~ Pull the mains plug 5 out of the wall
socket before you clean the hair dryer.
WARNING! Risk of material damage!
~ Do not use any astringent or abrasive
cleaning agents.
Clean the device regularly. Particularly en-
sure that the air inlet 3 and the air outlet 2
are free of dust, hair and fluff.
• Wipe down the housing and the protec-
tive grid 4 with a damp cloth.
• Remove the styling attachment 11 or the
diffuser 1 from the hair dryer. Hold the
hair dryer with the air outlet 2 pointing
downwards. Clean the protective discs
using a brush.
Cleaning the protective grid
1. Figure B: rotate the protective grid 4
a short way anti-clockwise and remove
it.
2. Hold the hair dryer with the air inlet 3
pointing downwards. Clean the inside
protective grid using a brush.
3. Clean the inside and the outside of the
protective grid 4 with a brush and, if
necessary, with a damp cloth. Allow
the protective grid 4 to dry completely.
4. Replace the protective grid 4 and ro-
tate it clockwise until it is firmly in
place.
Cleaning the attachments
1. Do not remove an attachment (11 or
1) from the hair dryer until it has
cooled down.
2. Wipe the attachment (11 or 1) with a
damp cloth.
17
GB