Cleaning; Cleaning The Housing - Silvercrest SHTT 2200 B1 Operating Instructions Manual

■ If you wish to dry your hair especially gently, or create a so-called "air-dried
wave", then use the finger diffuser 9. Start by removing the styling jet 1 with a
downwards snapping motion.
Fit the finger diffuser 9 by pushing it with light pressure onto the hairdryer so
that it snaps into place and sits evenly on the hairdryer.
If you no longer require the finger diffuser 9, wait until the appliance has
cooled down and pull it off with a downwards snapping motion:
■ Before you comb your hair out, allow it to cool so that the shaping and styling
can retain its form.
You can use the cold air button 8
■

Cleaning

RISK OF ELECTRIC SHOCK
► Always remove the plug from the mains power socket before cleaning the
appliance.
► UNDER NO CIRCUMSTANCES should you immerse the appliance in
water or other liquids during cleaning!
► After being cleaned, the hairdryer must be completely dry before using it
again.
WARNING – RISK OF INJURY!
► Allow the appliance to cool sufficiently before cleaning it.
CAUTION – PROPERTY DAMAGE!
► Do not use any aggressive cleaning liquids or solvents. They could damage
the surface.

Cleaning the housing

■ Use a soft cloth lightly moistened with a mild soap solution to clean the housing
and attachments.
■ Dry all parts thoroughly before re-using the appliance.
■ 8 │ GB │ IE
to cool your hair down.
SHTT 2200 B1