Advertisement
September 2007
mA OUTPUT Option
7-28
The mA Output submenu is used to individually enable or disable
error handling for fifteen different 4-20 mA analog output error
conditions. In addition, the type of response to the error may be
specified. To program this menu, see Figure C-9 on page C-9 and
proceed as follows:
•
The DriftCal Offset Error is generated when an error occurs during
an offset gas (one-gas) calibration.
ENABLE/DISABLE ERRORS
DriftCal Offset Error?
DriftCal Offset Error response:
disable
[ENABLE]
If the Enable option was selected above, one or both of the following
additional prompts appear. Otherwise, skip over these prompts.
Set mA Output Error response:
[force high] force low force to value
If the Force to Value option was selected above, the following
additional prompt appears. At that prompt, values from 0.00 to 25.00
may be entered. A 0.00 value forces a 0-3 mA output signal, and a
25.00 value forces a 22-26 mA output signal.
Enter mA Output Error Value
mA [xx.xx]
ENABLE/DISABLE ERRORS
DriftCal Offset Error?
•
The above programming sequence is repeated for all other error
conditions in this submenu (see the Terminal submenu on pages
7-22 to 7-27 for a list and description of all available options). As
usual, press
[NO]
to move between the options and press
to program the displayed option.
[ENTER]
When ready, you may exit this submenu at the Done? option, as
described in the Terminal submenu on the previous page.
Press
to skip this error, or
[N]
press
or
to set it.
[Y]
[Enter]
Press
to select the desired
[N]
option, then press
or
[Y]
[Enter]
confirm your selection and move
to the next prompt.
Press
[N]
to select the desired
option, then press
[Y]
or
[Enter]
confirm your selection and move
to the next prompt.
To accept the current value, press
[Y]
or
[Enter]
. To change the
current value, use the numeric
keys to enter a new value and
press
or
twice.
[Y]
[Enter]
Press
to move on to the next
[N]
error.
[YES]
Advanced Programming
to
to
or
Advertisement
