Commands By Function Or Group - Fluke 4180ETRS Operator's Manual

Commands by Function or Group

In this section, the commands are arranged into the following groups, see Table 5:
• Calibration Commands - commands for the Product calibration parameters.
• Main Screen Commands - commands for parameters displayed on the main screen.
• Program Commands - commands for program setup and status.
• Setup Commands - commands for setting up communication, display, password, measure, and
operation parameters.
• System Commands - commands to report and change the status of the Product.
• Temperature Commands - commands for control temperature and cutout functions.
Calibration - Controller
Calibration – IR Target
Main Screen
Setpoint
Program - Select
Program - Run
Program - Edit
Table 5. Commands by Function or Group
Screen Parameter
TEMP PB SOUR:LCON:PBAN
TEMP INT SOUR:LCON:INT
TEMP DER SOUR:LCON:DER
WAVELENGTH SOUR:CAL:WAV
(none) SOUR:CAL:EMIS
IR CAL 1 SOUR:CAL:PAR1
IR CAL 2 SOUR:CAL:PAR2
CAL DATE SOUR:CAL:DATE
(apparent temperature) SOUR:SENS:DATA [TEMP]
SETPT SOUR:SPO
(graphic) SOUR:STAB:DATA
(none) SOUR:STAB:TEST
HEAT % OUTP:DATA
ENABLE OUTP:STAT
IRT E: SOUR:EMIS
CAL L SOUR:CAL:WAV
°C/°F key UNIT:TEMP
SETPT SOUR:SPO
SETPOINT 1 SOUR:LIST:SPO1
SETPOINT 2 SOUR:LIST:SPO2
SETPOINT 3 SOUR:LIST:SPO3
SETPOINT 4 SOUR:LIST:SPO4
SETPOINT 5 SOUR:LIST:SPO5
SETPOINT 6 SOUR:LIST:SPO6
SETPOINT 7 SOUR:LIST:SPO7
SETPOINT 8 SOUR:LIST:SPO8
PROGRAM PROG:SEL
TEST STATUS PROG:STAT
ADVANCE PROG:PROM:ADV
Digital Communication Interface
Command
Unconditional
Unconditional
Unconditional
Unconditional
N/A
Unconditional
Unconditional
Unconditional
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Precision Infrared Calibrator
Password
Protection Group Read/Write
R/W
R/W
R/W
R/W
R
R/W
R/W
R/W
R
R/W
R
R
R
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
W
25