Table of Contents
Advertisement
4180ETRS
Operators Manual
RUN PROG
Use the RUN PROG(RUN PROGRAM) menu to access the program status feature.
PROGRAM (view Only)
The PROGRAM parameter indicates the number of the program that is selected.
NAME (view Only)
Program NAME indicates the program name. To set the program name, see the PROG:[n]NAME serial
command. Example: a thermometer model number.
STATUS
The STATUS option controls the state of the program. The user selects RUN to run the program or
OFF to turn the program off.
SYSTEM MENU
Use the SYSTEM MENU to set up the display settings, communications protocol, password settings,
calibrations settings, and to view system information.
SYSTEM SETUP
The SYSTEM SETUP menu contains the menus for the display and communications parameters.
DISPLY SETUP
The DISPLY SETUP (DISPLAY SETUP) menu contains the language selection, decimal separator,
and keypad sound parameters.
LANGUAGE
See Languages.
DECIMAL
Use the DECIMAL parameter to determine the decimal separator: a comma or a period. Push the right
or left arrow to select the desired decimal separator and then push ENTER to accept the selection.
KEY AUDIO
The KEY AUDIO parameter (F1 and F3 pushed simultaneously) enables or disables the button push
beep.
COMM SETUP
The COMM SETUP (COMMUNICATIONS SETUP) menu contains the serial interface parameters. The
parameters in the menu are: BAUD RATE and LINEFEED.
BAUD RATE
The BAUD RATE parameter determines the serial communication transmission rate or baud. BAUD
RATE may be programmed to 1200, 2400, 4800, 9600, 19200, or 38400 baud.
LINEFEED
The LINEFEED enables (ON) or disables (OFF) transmission of a line feed character (LF, ASCII 10)
after transmission of any carriage return. The LINEFEED default setting is on. The line-feed parameter
can be turned on or off as needed.
20
Advertisement
Table of Contents
