Closing Force Adjustment; Maximum Closing Force Adjustment (100%) - Only For Motors From 32 Nm - CHERUBINI Wave RX Instructions Manual

+
B C
Tn
This system, the only one of its kind, guarantees
that cassette-awnings
without any danger of the canvas suffering
excessive traction. The system works in all kinds of
applications, thanks to the possibility of manually
adjusting the closing force. The motor is factory set
to a closing force of 40% of the nominal torque (e.g.:
40% of 50 Nm = 20 Nm). This force can be changed very
easily by the remote control. It can be reduced by 20%
or increased up to 70%, depending on the desired result.
MAXIMUM CLOSING FORCE ADJUSTMENT (100%)
A close attention on activating this function is recommended, excessive closing force may
damage the awning.
By activating this function the motor will apply its maximum nominal torque, (e.g. 100%
of 50 Nm = 50 Nm).
Tn: Already programmed remote control
+
B C
Tn

CLOSING FORCE ADJUSTMENT

A
remain perfectly
- only for motors from 32 Nm -
A
70 %
closed,
40 %
20 %
34
A
B
C
2 sec
+
A C
2 sec