Power Supply Voltage Display - TYT TH-9000D User Manual

Hide thumbs Also See for TH-9000D:

User manual (38 pages)

Table Of Contents

Table of Contents

Fixed Station Operation

Ineed a separate 13.8V DC power supply (not included) , power supply as optional

accessories. Please contact local dealer to require.

The recommended current capacity of your power supply is 12A.

1. Connect the DC power cable to the regulated DC power supply and ensure that the

polarities are correct. (Red: positive, Black: negative).

Do not directly connect the transceiver to an AC outlet.

Use the supplied DC power cable to connect the transceiver to a regulated power supply.

Do not substitute a cable with smaller gauge wires.

Black

Regulated power supply

DC power cable with fuse holder

2. Connect the transceiver's DC power connector to the connector on the DC power cable.

Press the connectors firmly together until the locking tab clicks.

NOTE:

Before connecting the DC power to the transceiver, be sure to switch the

transceiver and the DC power supply OFF.

Do not plug the DC power supply into an AC outlet until you make all connections.

Regulated

power supply

Red

Replacing Fuses

If the fuse blows, determine the cause, then correct the problem. After the problem is

resolved, replace the fuse. If newly installed fuses continue to blow, disconnect the power

cable and contact your autho- rized TYT dealer or an authorized TYT servi-cecenter for

assistance.

Fuse Location

Transceiver

Supplied Accessory DC

power cable

Only use fuses of the specified type and rating, otherwise the transceiver could be damaged.

NOTE: If you use the transceiver for a long period when the vehicle battery is not fully

charged, or when the engine is OFF, the battery may become discharged, and will not have

sufficient reserves to start the vehicle. Avoid using the transceiver in these conditions.