Table of Contents
Advertisement
When first bit of Exa byte in frequency displays "D",it indicates
DTMF function enable.
When first bit of Exa byte in frequency displays "T",it indicates
2Tone function enable.
When first bit of Exa byte in frequency displays "
5Tone function enable.
This function can be temporarily used in channel mode. Once the radio is turned off or
switched to another channel, the temporary setting will be erased and back to initial settings.
Scan Skip
In Channel mode,press
then press
ten digit and unit digit,it means current channel is scan skip. Repeat above operation to set
scan or scan skip in currentchannel.
1. decimal point displayed between frequency's ten digit and unit digit,it means current
channel is scanned skip.
2. decimal point is not displayed between frequency's ten digit and unit digit,it means current
channel is scanned.
Frequency/Channel scan
In corresponding mode,press
then press
In scanning mode,press
/
UP
DOWN
48
",it indicates
,decimal point displayed between frequency's
key to enter into scanning.
to change scan direction.
Busy Channel Lockout
BCLO is to disable transmitting while RX signal is received. Once the channel is busy
and you press PTT, the radio will beep as warning and get back to receiving.
1. In standby,press
,then press
2. Press [
/
] to select the desired value.
UP
DOWN
BU: Enable BCLO, Carrier lockout, transmitting is inhibited when current channel receives
a matching carrier;press [PTT] to emit error voice prompt.
RL: Enable BTLO, transmitting is inhibited when current channel
receives a matching carrier but dis-matching CTCSS/DCS.press [PTT] to emit error voice
prompt It can transmit in any receiving status.
OFF: Busy channel lockout is disabled.
3. Press number keys to confirm and exit.
NOTE: This function can be temporarily used in Channel mode . Once the radio is turned
off or switched to another channel, the temporary setting will be erased and back to initial
settings.
Reverse TX/RX
TX frequency turns to RX frequency & RX frequency changes
to TX frequency. The signaling will also be reversed if CTCSS/DCS
signaling exited in this channel.
1. In standby,press
,then press
2. Press [
/
] to select the desired value.
UP
DOWN
to enter into Busy Channel Lockout.
,LCD displays "REV--OF".
49
Advertisement
Table of Contents
