Tot (Time-Out Timer); Ctcss/Dcs Encode And Decode; Talk Around; Voice Prompt - TYT TH-9000D User Manual

ON:Enable Frequency Reverse
OFF:Disable Frequency Reverse
3. Press number keys to confirm and exit.
NOTE: This function can be temporarily used in Channel mode . Once the radio is turned
off or switched to another channel, the temporary setting will be erased and back to initial
settings.

TOT (Time-out timer)

The time-out timer limits the amount of transmitting time. When you reach the time limit
which has been programmed by your dealer, your transmission will be cut off. In order to
transmit again, you must release PTT button to reset the timer.
1. In standby,press ,then press
2. Press [ / ] to select the desired value.
UP DOWN
3. Press number keys to confirm and exit.

CTCSS/DCS Encode and Decode

1. In standby,press ,then press
2. Repeat above operation to set as below:
LCD displays T icon,it indicates CTCSS encode set in current channel.
LCD displays T and SQ icon,it indicates CTCSS encode and decode set in current channel.
LCD displays DCS icon,it indicates DCS encode and decode set in current channel.
3. In corresponding icon,press [ /
UP
and decode.
50
ìLCD displays "TOT-X".
to enter into CTCSS/DCS Encode and Decode.
] to select the desired CTCSS/DCS encode
DOWN
4. Press 3 or to confirm and exit.
* P
NOTE:This function can be temporarily used in Channel mode. Once the radio is turned off
or switched to another channel, the temporary setting will be erased and back to initial
settings.

Talk Around

By Talk Around function,you can directly communicate with other radios in your group
in case the repeater is not activated or when you are out of the repeater range. The transceiver
will transmit by RX frequency with its CTCSS/DCS signaling.
1. In standby,press ,then press
2. Press [ / ] to select the desired setting .
UP DOWN
ON:Enable Talk Around
OFF:Disable Talk Around
3. Press number keys to confirm and exit.
NOTE: This function can be temporarily used in Channel mode . Once the radio is turned
off or switched to another channel, the temporary setting will be erased and back to initial
settings.

Voice Prompt

The prompting tone provides confirmation of entry, error status or malfunctions of the
transceiver. You can enable or disable this function.
1. In standby,press ,then press
2. Press [ / ] to turn on/off BEEP voice prompt.
UP DOWN
key,LCD displays "TALK--OF".
,LCD displays "BEEP--XX".
51