Table of Contents
Advertisement
SeTuP
1. The zone boundary magnet kit is supplied with two dif-
ferent types of magnet clips designed to mount the mag-
nets to the reflow oven rail. Reflow ovens may have differ-
ent conveyor rails than the one used in these instructions,
so determine which type will best mount the magnets in
your oven. Modifications to the clips may be necessary to
properly mount magnets.
2. Open the top of the oven and determine where to place the start of the first zone magnet.
3. Adjust the conveyor to match the RIDER width. (The width of the pallet is engraved on the
back edge of the pallet top.)
4. Slide the RIDER on the conveyor until the front sensor reaches the magnet.
5. Center a magnet and clip on the first zone boundary within 0.5" to 1.0" (1.3-2.5cm) from
the edge of the pallet and slide it past the magnet.
ZOne MAGneT inSTALLATiOn
11
Advertisement
Table of Contents
