Assembly - Standard Ceiling Mount
1
Attaching the blades
□
Attach a blade (F) to the fan motor assembly (E) by inserting
the blade (F) into slots in the side of the fan motor assembly (E)
and aligning the three screws holes in the blade with the holes
in the center flywheel and secure with screws (AA).
□
Make sure all the screws are firmly tightened.
□
Repeat these steps for the remaining blades.
3
Preparing for standard mounting
NOTE: The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
□
Pull off the canopy bottom cover (JJ) from the canopy
□
Loosen the two canopy screws (HH) located on the bottom of the
mounting bracket (A), and turn the canopy counterclockwise
to remove the mounting bracket (A) from the canopy (C).
F
AA
E
2
Remove the hanger
ball from downrod
□
Remove hanger ball from downrod by loosing the set screw and
removing the pin as shown in illustration. Keep parts. Remove
preassembled keeper pin and cross pin from downrod. Keep
parts
Set screw
HH
7
Please contact 1-855-HD-HAMPTON for further assistance.
Pin
Hanger ball
A
C
JJ
HAMPTONBAY.COM