Advertisement
Assembly - Hanging the Fan (continued)
7
Mounting the fan-motor assembly
(standard mount)
WARNING: When using the standard ball/downrod
mounting, the tab in the ring at the bottom of the
mounting bracket must rest in the groove of the hanger
ball. Failure to properly seat the tab in the groove could
cause damage to the wiring.
NOTE: The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
□
Align the locking slots of the canopy (C) with the two screws (HH)
and alignment post (KK) in the mounting bracket (A).
□
Push up the canopy (C) and turn clockwise until the alignment
post (KK) engage to the round hole and the screws (HH) engage
to the key slots.
□
Firmly tighten the two mounting screws (HH).
□
Align the oval shape on the canopy (C) with canopy bottom cover
(JJ), Push up the canopy bottom cover (JJ) until the screw (HH)
heads engage to the slots on the canopy bottom cover (JJ) so
that the magnetic canopy bottom cover (JJ) can be attached to
the bottom of the canopy (C) properly.
Assembly - Attaching the Lights
1
Attaching the decorative shade
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
□
Place the decorative shade (G) into the light kit pan, aligning the
three flat areas on the top flange of the decorative shade (G)with
the raised dimples in the light kit pan.
□
Turn thedecorative shade (G) clockwise until it stops.
KK
Light kit pan
12
I
A
HH
C
B
JJ
D
G
Hide quick links:
Advertisement
