Addi-Data APCI-8001 Commissioning Manual page 54

54
External power supply:
Design:
PC power supply:
Cascading:
Controller software:
Control times:
Interpolation:
Connectors:
Other options:
Manufacturing:
Test:
24 V power consumption depending on load of the digital outputs
Short plug-in boards, x8 multi-layer, 1 slot required
3.3 V/0.8 A,
Note: 3.3 V supply voltage is sometimes not provided by older
motherboards.
5V/1.0A,
APCI-8001: up to a total of 8 axes with OPMF option
PIDF (PID controller with forward compensation)
1.28 ms (idle time approx. 0.05 ms)
Optional approx. 0.3 ms to 4 ms
2D .. 3D linear, 2D .. 3D circular, helical, asynchronous and
synchronous interpolation with secondary axes
APCI-8001: 50-pin SUB-D connector complete peripheral
connection
10-pin FB connector with 3 potential-free relay points
10-pin FB connector for CAN-Bus (Option),
10-pin FB connector for Interbus (Option)
Spline and CAD interpolation, electronic gear unit (e.g. Gantry axes),
G-Code programming, velocity limitation at profile transition through
look ahead, surface area processing, support of non-feed rate axes,
scanner functionality, ELCAM functionality (cam plate control), flying
saw, SSI absolute value encoder, PWM manipulated value outputs.
The board is manufactured according to DIN ISO 9001.
The board is tested according to CE directives.
CM / C M
OMMISSIONING ANUAL