Table of Contents
Advertisement
13. Configure the MoIP Receivers
MoIP Video Receivers
1. For displays that only support 1080p and/or HDCP 1.4, set the corresponding receiver to
match this requirement to allow video to pass. 4K video input into transmitters does not
show on 1080p and/or HDCP 1.4 displays.
2. Set each receiver to
metadata to pass, resulting in 4K HDR 30Hz.
3. Set each receiver to 2160p 30Hz to displays that are 4K, but don't support HDR.
4. If desired, choose drop down for
the most common for the top row of video walls where TVs are hung upside down, so bezel
logos are right-side up.
5. When using a receiver with a
downmixing feature (B-900-MOIP-
4K-RX-2AC), you can configure
downmixing mode (Auto, 2CH, or
Bypass) and audio latency (up to 250
milliseconds).
Note:
• The video output resolution can be set to 2160p (4K) at 30Hz or 25Hz or 1080p (2K) at
60Hz or 50Hz.
• When the MoIP RX is set to 2160p 30Hz, instead of Pass-Through, the receiver always
outputs 4K 30Hz 4:4:4 8 bit color and 4K HDR is limited to 8-bit color only. However, the
display shows content as 4K HDR and output higher brightness and contrast.
Passthrough
for the displays that support 4K HDR to allow the HDR
Rotation
between 90, 180, or 270 degrees. 180 degrees is
23
Advertisement
Table of Contents
