Powering Up The System - Binary B-900-MOIP Series Installation & Setup Manual

5. Access Local UI using Remote Access
1. Log in to the MoIP Controller (default username/password is binary / binary). You are
prompted to change the username and password upon first login. The user name and
password can be changed under the
2. It is recommended to apply a static IP
click Enable. Apply a static address to the MoIP controller on the same ip address range.
Save
Click to apply.
6. Update the MoIP Controller Firmware
Available firmware updates are visible in the
provided in OvrC to complete.
7. Power off the MoIP Switch, then Connect Devices
1. Connect sources via HDMI to the MoIP transmitters.
2. Connect displays or A/V receivers via HDMI to the MoIP receivers.
3. The transmitter and receiver are PoE powered (no power supply is included).
4. The controller must be powered by the included external power supply.

8. Powering Up the System

1. Turn on all displays, sources and other related A/V equipment.
2. Verify the MoIP Controller is also powered up.
3. Apply power to the MoIP Switch. This supplies power on all connected MoIP devices.
.
Configure> Account
address. Navigate to the
Device List
for that location in OvrC. Follow steps
17
Management.
Configure >IP Settings and