3Com OfficeConnect 3CXSH654B User Manual page 51

N Z
EW EALAND
VCCI C B
LASS
U G
SER UIDE VERSION
Not all phones connected to the phone port will respond to incoming ringing. Do not report this as a fault unless the same
phone will not respond to ringing when connected to a standard phone socket.
This equipment shall not be set up to make automatic calls to the Telecom 111 Emergency Services.
The grant of a Telepermit for a device in no way indicates Telecom acceptance of responsibility for the correct operation of that
device under all operating conditions. In particular, higher speeds at which this modem is capable of operating depend on a
specific network implementation which is only one of many ways of delivering high quality voice telephony to customers.
Failure to operate should not be reported as a fault to Telecom.
In addition to satisfactory line conditions a modem can only work properly if:
a) it is compatible with the modem at the other end of the call and,
b) the application using the modem is compatible with the application at the other end of the call – e.g. accessing the Internet
requires suitable software in addition to a modem.
This equipment should not be used in a manner which could constitute a nuisance to other Telecom customers.
Some parameters required for compliance with Telecom's PTC Specifications are dependent on the equipment (PC) associated
with this modem. The associated equipment shall be set up to operate within the following limits for compliance with Telecom
specifications:
a) There shall be no more than 10 call attempts to the same number within any 30 minute period for a single manual call
initiation
b) The equipment shall go back on-hook for a period of not less than 30 seconds between the end of one call attempt and the
beginning of the next.
c) Automatic calls to different numbers shall be not less than 5 seconds apart.
d) When used in the Auto-Answer mode, the S0 register must be set with a value between 2 and 5. This ensures:
i. A person calling your modem will hear a short burst of ringing before the modem answers. This confirms that the call has
been successfully switched through the network.
ii. Caller identification information (which occurs between the first and second ring cadence) is not destroyed.
The code for Call Waiting disable is *52 on the Telecom New Zealand telephone network.
This is a Class B product based on the standard of the Voluntary Control Council for Interference from information Technology
Equipment (VCCI). If this is used near a radio or television receiver in a domestic environment, it may cause radio interference.
Install and use the equipment according to the instruction manual.
1.0