3Com OfficeConnect 3CXSH654B User Manual page 33

6 When the Select OEM Option window opens, select SH654B - 3Com
OfficeConnect LAN + Global Modem -(Fast Ethernet) and click OK.
7 The Network Adapters list shows a check mark next to the 3Com LAN+Modem
card. Click Next to continue.
8 In the Network Protocols list, place a check mark next to each network protocol
required for your site and click Next.
9 In the Network Services window, place a check mark in the box next to each
desired service. Unless you are following specific guidelines from your MIS
department, select the default settings.
10 Click Next to install the selected components.
11 When prompted, enter the path to the Windows NT installation files (for example,
D:\i386 on the NT CD) and click Continue.
When the system prompts again for NT files, specify the CD-ROM drive and click
Continue.
12 In the 3Com LAN+Modem card dialog box, accept the default settings and click
Continue.
Depending on your computer's current settings, a TCP/IP setup windows may
appear. Select the options that are required for your site and continue.
13 When the window for enabling or disabling protocols opens, click Next.
14 When NT is ready to start the network, click Next to copy the network files.
15 Provide your computer name and workgroup or domain name when prompted.
16 When the system displays "Networking has been installed on your computer,"
click Finish.
17 When prompted to reboot the computer, remove the LAN+Modem card
Installation CD from the CD-ROM drive and click Yes.
Setup With Networking Already Installed
This procedure assumes that Windows NT networking is already installed on your
notebook computer. If networking is not yet installed, see "Setup With No
Networking Installed" on page 26.
1 In the Control Panel, double-click Network.
If the system prompts: "Windows NT Networking is not installed. Do you want to
install it now?", use the procedure for "Setup With No Networking Installed" on
page 26.
2 Open the Adapter tab and click Add.
3 Click Have Disk. Put the LAN+Modem card Installation CD in the CD-ROM drive
and click OK.
4 When the Select OEM Option window opens, select SH654B - 3Com
OfficeConnect LAN + Global Modem -(Fast Ethernet) and click OK.
5 In the 3Com LAN card dialog box, accept the default settings and click Continue.
The default settings work in most instances. However, you may specify network
link settings, auto polarity, and IRQ and I/O values.
6 After Windows copies all of the required files, it displays the LAN card name,
SH654B - 3Com OfficeConnect LAN + Global Modem -(Fast Ethernet). Click Close.
Setup Using Point Enabler 27