Multiple Adapters In A Client; One Adapter In A Server - 3Com EtherLink 3C590 User Manual

3-8 C 3: I
HAPTER NSTALLING THE

Multiple Adapters in a Client

If you are running NetWare and have installed multiple
adapters in a PCI computer, follow these steps:
1 With the main menu displayed (Figure 3-2), select Network
Drivers.
2 When the Network Drivers screen appears, select Install
Novell NetWare Drivers.
3 When the Novell NetWare Drivers screen appears, select
Copy DOS ODI Client Driver.
A message about PCI adapter backward compatibility
appears, followed by instructions to specify a target drive.
The default drive is C:\NWCLIENT.
If you are using an ODI driver with multiple adapters already
installed, and you have not updated the NET.CFG file, the
message shown below appears:
NetWare DOS ODI client Multiple EtherLink III
Adapters found.
Use NET.CFG to specify I/O Port.
Specify which adapter you want the driver to recognize by
adding the I/O port address to the NET.CFG file using the
PORT=XXXX parameter.

One Adapter in a Server

If you are running NetWare and have installed a single
adapter in a PCI computer that is functioning as a server,
follow the instructions in this section.
The 3C59X EtherDisk diskette contains a NetWare 4.x server
driver (3C59X.LAN) and the NetWare Loadable Modules
(NLMs) that enable the NetWare 4.x driver to be used with
NetWare 3.11 or 3.12 software. These files are found in the
\NETWARE subdirectory.
N D
ETWORK RIVERS