3Com 3101 User Manual page 51

From the telephone, you can set call forwarding using feature codes. Use
the NetSet utility to see your call forwarding settings. Your administrator
can also set programmable access buttons for call forwarding. And you
can select Call Forward All directly from the display panel.
Forward to Mail
From the telephone, you can set your 3Com Telephone so that all
incoming calls go directly to your default call coverage point, usually your
voice mailbox. You can change the destination to the Auto Attendant or
receptionist or a different telephone number. This feature is referred to as
FWD MAIL, Forward to Mail, Forward All Calls to Voice Mail, and Forward
All Calls to VM. When Forward to Mail is in effect, your telephone rings
once before forwarding the call to your default call coverage point.
On a 3Com Basic Telephone:
1 Pick up the handset.
2 Press Feature + 440.
3 To turn off FWD MAIL, pick up the handset and press Feature + 440
again.
To set your default call forwarding destination, use the NetSet utility. See
"Default" later in this section.
To prevent the telephone from ringing even once, use the Do Not Disturb
feature (see "Do Not Disturb"
feature (see "Call Forward All"
Call Forward No Answer, Call Forward Busy, and Call Forward All override
this Forward to Mail setting if they are in effect. If you turn off Forward to
Mail and no other call forward options are in effect, unanswered calls still
go to your default call coverage point but after the number of rings
specified in NBX NetSet > User Information > Call Forward Default.
To view your current Forward to Mail setting, log in to
NBX NetSet > User Information > Feature Settings and see Forward
All Calls to VM.
Forwarding Incoming Calls
in Chapter 6) or use the Call Forward All
later in this section).
51