Table of Contents
Advertisement
7
Setting up the screening station
2. Mark the screening position.
• The distance from the camera to the screening position shall be 160 cm (5.2 ft.).
• Clearly mark the screening position, e.g. by a floor sticker.
3. Make sure the system detects faces of persons with different heights.
3.1.
Start the FLIR Screen EST and make sure the screening window is displayed
on the visitor display.
3.2.
Check that a live image is displayed in the screening window when persons of
different heights (or a tall person bending the knees) stand in front of the
camera.
• A 170 cm (5.6 ft.) tall person shall stand at the screening position.
• Shorter persons shall move closer to the camera.
• Longer persons shall move further back from the camera.
3.3.
If no live image is displayed in the screening window, you must adjust the Ex-
pected face size settings. See 7.8.2 Select the FLIR Screen EST settings.
4. For accurate temperature measurements, it is important to adjust the camera focus.
4.1.
Place a 170 cm (5.6 ft.) tall person at the screening position.
4.2.
Adjust the focus on the face by using the focus controls on the Live page in
the operator window.
4.3.
Once the focus is correctly adjusted, make sure the focus is not changed.
5. Make sure the backdrop is correctly placed. Look at the live image in FLIR Screen
EST and make sure the camera only sees the backdrop.
7.10 Place the supporting material
Place the queue management and information material. See also section 3.6 Supporting
material.
#T810558; r. AC/68383/68383; en-US
18
Advertisement
Table of Contents
