Table of Contents
Advertisement
Error messages
Error message
The application
Appears when an error is occurred in
XXXX (process
the terminal or function. Tap "Force
XXXX) has stopped
close"/"OK" and then retry.
unexpectedly./XXXX
(XXXX) has stopped.*
Airplane mode on.
Appears when you try to make a call
Turn Airplane mode
with the Airplane mode is set. Set the
off to make calls.
Airplane mode off, and retry.
Mobile network not
The docomo nano UIM card is not
available.
correctly installed to the terminal. Make
sure that the docomo nano UIM card is
correctly attached.
Please wait for a
Appears when communication is
while (Voice service)./
restricted due to access congestion on
Please wait for a
call/communication. Operate again after
while (Data service).
the restriction is released.
Switching to video
Appears when switching to video call
call failed
fails. Switching is not possible during
emergency call and audio guide, when
the other party is using Catch Phone (call
waiting service), when calling outside the
Xi area, etc.
Request to switch to
Appears when the other party rejects
video call rejected
switching to video call, etc.
Failed to switch to
Appears when switching to voice call fails
voice call
due to communication error, etc. Wait for
a while and retry the operation.
Unable to dial
Appears when making video call fails.
Make sure that you are in Xi Area, and
check the calling mode settings, settings
of mobile network, etc.
Unable to set during
Appears when you try to change the
a call session
calling mode settings during a call. Set
after you end the call.
Cause and remedy
Page
P.88
P.17
P.43
P.44
P.45
P.43
P.43
P.50
P.86
P.50
Error message
Unable to set
because you are
connected to a
-
network other than
docomo's
Unable to set due to
no signal
Storage space
running out
Some of the system
functions may not
work
-
Unable to update
software. A network
or server error
occurred. Try again
later.
Camera failed.
Exit Camera. Battery
temperature too high.
Disabling built-in apps
may cause errors in
other apps.
120
Cause and remedy
Appears when you try to change the
calling mode settings when the network
you are connected to is not docomo.
Connect to a docomo network.
Appears when you try to change the
calling mode settings when you are out
of the service area. Set in a place with
good reception.
Appears when available memory of
the Device memory is low. If you keep
using the terminal, some functions or
applications may not work. Delete data
such as one for application or media
contents to increase available memory
space.
Communication with the server is failed.
Wait for a while and retry the operation.
Appears when activating Camera fails.
Wait for a while and retry the operation
or turn the power off then turn on the
terminal.
Appears when the temperature of the
terminal becomes high and the Camera
closes. Wait for a while and retry the
operation or turn the power off then turn
on the terminal.
If you disable application, other
applications linking to the disabled
application may not work properly. If
other application does not work properly
when "OK" is tapped and application is
disabled, enable the application.
Page
P.50
P.112
P.50
P.39
P.106
P.123
P.20
P.74
P.74
P.94
Appendix/Index
Advertisement
Table of Contents
