Default Settings - 3Com SuperStack 3 3226 Getting Started Manual

Default Settings

Table 5 shows the default settings for the Switch:
Table 5 Default Settings
Feature
IP Configuration
Port Status
Port Speed
Duplex Mode
Flow Control
Broadcast Storm Control
Virtual LANs (VLANs)
Link Aggregation Control
Protocol (LACP)
Multicast Filtering
Rapid Spanning Tree Protocol Enabled
Spanning Tree Fast Start
Traffic Prioritization
Port Security
If you initialize a Switch unit by selecting System > Control > Initialize in
the Web interface or by entering system control initialize in
the Command Line Interface, the following settings are retained to allow
you to connect to and manage the Switch:
IP Address
Subnet Mask
Default Gateway
Switch
Automatic by DHCP client
Enabled
All ports are auto-negotiated
All ports are auto-negotiated
Disabled in half duplex 10/100 ports
Auto-negotiated in full duplex 10/100 ports
Disabled for 10/100/1000 ports
Enabled
All ports belong to the untagged Default VLAN
(VLAN 1) with IEEE Std 802.1Q-1998 learning
operational
Disabled per port
IGMP Filtering enabled
Enabled on 10/100 ports
Disabled on 10/100/1000 ports
All ports prioritize NBX VoIP traffic (LAN and IP).
All ports set to "best effort" for all other traffic.
Disabled per port
Default Settings 17