Changing A Talkgroup During/On Receiving A Call; Selecting A Range; Activating/Deactivating Scanning - Motorola TETRA MTM800 Manual

Changing a Talkgroup during/on receiving a call

You can select a group folder without an interruption on
receiving and during a call.
Selecting a group on receiving a call
If you select a group and a non-Emergency call is incoming,
MTM800 display remains unchanged while you hear the call.
During the selection you cannot see calling party information.
When an Emergency Call is received, then selecting is aborted,
the MTM800 switches to the group mode and Emgcy In Use
display appears.
Selecting a group during a call
If you start selecting a group during a call, Group In Use or
Emgcy In Use display disappears.

Selecting a Range

To select a range:
1. In Group Mode, press
2. Use the navigation key to scroll through the ranges.
3. Press
the call in the new range).
The Service provider can configure range scrolling to:
• Stay in range — when the range end is reached during
talkgroup scrolling, further scrolling restarts the range
talkgroup list.
• Scroll to next range — when the range end is reached during
talkgroup scrolling, further scrolling switches to the talkgroup
list in the next range.

Activating/Deactivating Scanning

See "Setting Talkgroup Scanning" on page 93.
34
to select the range (or press and hold PTT to start
Ok
followed by
Optns, Range.