HB Products HBLC Manual page 9

Connection diagram for sensors with control ca-
ble for all common stepper motor valves — here
shown with Carel E2V
Note: The sensor is powered via
the M12 plug only. Do not supply
the sensor via the cable.
Color coding
A+ = yellow(2)
A- = white (4)
B- = green (1)
B+= brown (3)
Rigid level sensor manual 01
Suited for
•
HBSLT/S and HBSLT–wire/S
•
HBSLC/S
1
+24V DC
2
- Common
3
AI Remote set point 4-20 mA
4
AO, 4-20 mA level
5
Run in signal
The sensor has a build in controller for a stepper valve. The sensor pro-
vides both the analog output via the cable to control the valve. The lev-
el measurement signal for the PLC comes via the M12 plug .
On pin 3 it is possible to send an analog 4-20 mA signal to the controller
and change the setpoint. The signal is scaled linear like analog output.
The cable is connected according to the drawing and the parameters
are set as shown in the next section.
May 2020
+
-
AO
AI
DO
For the stepper motor setup a
special menu is activated
HBproducts.dk
PLC
9