Diagnostic (calibration of sensor)
Here you make the calibration of the sensor. If the sensor is operating in one of the predefined liquid it is delivered with a
calibration and does normally not need further calibration. If you need higher accuracy the sensor can be calibrated
Here you can see and change the zero
calibration.
The value is normally calculated based
on an automatic calibration and should
not be changed
Here you can see
the actual meas-
urement value
Use this button to
make the zero
calibration
Rigid level sensor manual 01
Here you can see and change the SPAN
which is a part of the calibration
The value is normally calculated based
on an automatic calibration and should
not be changed
Use the button and the field to
make a calibration to a known level
between 1 and 100%
May 2020
HBproducts.dk
Visualization of the
control signal and the
level
17