3Com 7757 Quick Reference Manual page 91

3Com Switch 7750 Family
Quick Reference Guide
traffic-accounting traffic-group
Use the traffic-accounting traffic-group command to create a traffic group or enter the view of an
existing traffic group.
Use the undo traffic-accounting traffic-group command to delete an existing traffic group.
traffic-bandwidth
Use the traffic-bandwidth command to activate the ACL for traffic identifying and provide bandwidth
guarantee for the corresponding traffic. This command is applicable to only the permit rule).
Use the undo traffic-bandwidth command to remove this function.
traffic-group
Use the traffic-group command to configure the domain to use a traffic group.
Use the undo traffic-group command to cancel the configuration.
traffic-limit traffic-priority traffic-red
Use the traffic-red command to enable the RED operation and set RED parameters.
Use the undo traffic-red command to remove the RED configuration.
traffic-redirect
Use the traffic-redirect command to enable the ACL to identify and redirect the traffic. This command is
applicable to the permit rules in an ACL only.
Use the undo traffic-redirect command to disable the traffic redirect function. .
traffic-redirect inbound ip-group
Use the traffic-redirect inbound ip-group command to redirect inbound packets that match a
specified ACL or ACL rule on an I/O Module.
Use the undo traffic-redirect inbound ip-group command to remove the inbound packet redirection
configuration.
traffic-redirect outbound ip-group
Use the traffic-redirect outbound ip-group command to redirect outbound packets that match a
specified ACL or ACL rule on an I/O Module.
Use the undo traffic-redirect outbound ip-group command to disable the outbound packet
redirection configuration.
traffic-remark
Use the traffic-remark command to enable the ACL for traffic identifying and tag the packet matching the
ACL with the external VLAN tag to implement the traffic-based flexible QinQ function.
Use the undo traffic-remark-vlanid command to disable the configuration.
traffic-share-across-interface
Use the traffic-share-across-interface command to enable traffic sharing across RIP interfaces, so as to
distribute traffic evenly over equal-cost routes across the interfaces on a router.
Use the undo traffic-share-across-interface command to cancel traffic sharing.
traffic-slot
Use the traffic-slot command to specify a traffic collection module.
Use the undo traffic-slot command to cancel the specified traffic collection module.
traffic-statistic udp-helper enable
Use the udp-helper enable command to enable the UDP-Helper function.
Use the undo udp-helper enable command to disable the UDP-Helper function.
udp-helper port
Use the udp-helper port command to specify a UDP-Helper destination port.
Use the undo udp-helper port command to disable a port from being a UDP-Helper destination port.
traffic-accounting traffic-group 1235
Traffic accounting view
System view
QoS view
Domain view
QoS view
QoS view
VLAN view
VLAN view
QoS view
RIP view
System view
System view