3Com 7757 Quick Reference Manual page 4

1148 acl
acl
Use the acl command to apply an ACL to filter Telnet users.
Use the undo acl command to disable the switch from filtering Telnet users using the ACL.
acl mode
Use the acl mode command to set the traffic classification mode for the device.
acl order
Use the acl order command to set the match order for the ACL rules sent to hardware.
active region-configuration
Use the active region-configuration command to activate the settings of an MST (multiple spanning
tree) region.
add-member
Use the add-member command to add a candidate device to a cluster.
address-check
Use the address-check enable command to enable the address checking function of the DHCP relay
agent.
Use the address-check disable command to disable the address checking function of the DHCP relay
agent.
address-check dhcp-relay
Use the address-check dhcp-relay enable command to validate the dynamic entries generated by the
DHCP relay agent.
Use the address-check dhcp-relay disable command to invalidate the dynamic entries generated by
the DHCP relay agent.
address-check field enable
Use the address-check field enable command to enable checking of the specified field.
Use the address-check field disable command to disable checking of the specified field.
address-check no-matched
Use the address-check no-matched enable command to forbid freely-connected clients to pass DHCP
security check.
Use the address-check no-matched disable command to allow freely-connected clients to pass DHCP
security check.
aggregate
Use the aggregate command to establish an aggregated record in the BGP routing table.
Use the undo aggregate command to disable the function.
am user-bind
Use the am user-bind command to bind the MAC and IP addresses of a user with a specified port.
Use the undo am user-bind command to cancel the binding.
apply as-path
Use the apply as-path command to add AS number before original AS path in Router-policy.
Use the undo apply as-path command to remove the added AS number.
apply community
Use the apply community command to set BGP community attributes in Route-policy.
Use the undo apply community command to cancel the BGP community attribute setting .
apply cost
Use the apply cost command to configure the route cost value of route information.
Use the undo apply cost command to cancel the apply statement.
3Com Switch 7750 Family
Quick Reference Guide
User interface view
System view
System view
MST region view
Cluster view
VLAN interface view
VLAN interface view
VLAN interface view
VLAN interface view
BGP view/BGP multicast address family view
System view/Ethernet port view
Route policy view
Route policy view
Route policy view