3Com 7757 Quick Reference Manual page 3

3Com Switch 7750 Family
Quick Reference Guide
holdtime
Use the holdtime command to configure the holdtime of a switch.
Use the undo holdtime command to restore the default holdtime value.
ip-pool
Use the ip-pool command to configure a private IP address range for cluster members on the switch to be
configured as the management device.
Use the undo ip-pool command to cancel the IP address range configuration.
snmp-host
Use the snmp-host command to configure an SNMP host for the member devices inside a cluster on the
management device.
Use the undo snmp-host command to cancel the SNMP host configuration.
abr-summary
Use the abr-summary command to enable route aggregation on an area border router (ABR).
Use the undo abr-summary command to disable route aggregation on an ABR.
access-limit
Use the access-limit command to set the maximum number of access users that can be contained in current
ISP domain.
Use the undo access-limit command to restore the default maximum number.
accounting
Use the accounting command to configure the accounting scheme that will be used by current ISP domain.
Use the undo accounting command to remove the accounting scheme used by current ISP domain.
accounting enable
Use the accounting enable command to enable the traffic accounting function on the traffic accounting
module.
Use the undo accounting enable command to disable the traffic accounting function on the traffic
accounting module.
accounting optional
Use the accounting optional command to open the accounting-optional switch.
Use the undo accounting optional command to close the accounting-optional switch.
accounting optional
Use the accounting optional command to open the accounting-optional switch.
Use the undo accounting optional command to close the accounting-optional switch so that users are
charged forcibly.
accounting-mode traffic
Use the accounting-mode traffic command to set the accounting mode to traffic accounting.
Use the undo accounting-mode traffic command to restore the default accounting mode.
accounting-on enable
Use the accounting-on enable command to enable the user re-authentication upon device restart
function.
Use the undo accounting-on enable command to disable the user re-authentication upon device restart
function and restore the default interval and maximum number of attempts to transmit Accounting-On packets.
Use the undo accounting-on send command to restore the default maximum number of attempts to
transmit Accounting-On packets.
Use the undo accounting-on interval command to restore the default interval to transmit
Accounting-On packets.
acl
Use the acl command to define an ACL and enter the corresponding ACL view.
Use the undo acl command to delete all entries of an ACL identified by a number or a name, or the entire
ACL.
holdtime 1147
Cluster view
Cluster view
Cluster view
OSPF Area view
ISP domain view
ISP domain view
Traffic accounting view
ISP domain view
RADIUS scheme view/ISP domain view
ISP domain view
RADIUS scheme view
System view