3Com 7757 Quick Reference Manual page 54

1198 mac-authentication timer
mac-authentication timer
Use the mac-authentication timer command to configure the timers used in centralized MAC address
authentication.
Use the undo mac-authentication timer command to restore a timer to its default setting.
md5-compatible
Use the md5-compatible command to specify IS-IS to adopt the MD5 algorithm compatible with other
manufacturers.
Use the undo md5-compatible command to specify IS-IS to adopt the default MD5 algorithm.
mdi
Use the mdi command to set the network types that can be identified by Ethernet ports.
Use the undo mdi command to restore the default network cable type that can be identified by Ethernet
ports.
memory { safety | limit }*
Use the memory limit limit-value command to configure the lower limit of the switch free memory.
memory auto-establish disable
Use the memory auto-establish disable command to disable the automatic restoration of routing
protocol connection (even if the free memory recovers to a safety value).
memory auto-establish enable
Use the memory auto-establish enable command to enable automatic restoration of routing protocol
connections when the free memory of the switch recovers to the specified value.
Use the memory auto-establish disable command to disable this function.
messenger
Use the messenger time enable command to enable the messenger function and set the related
parameters.
Use the messenger time disable command to disable the messenger function.
Use the undo messenger time command to restore the messenger function to its default state.
mirrored-to
Use the mirrored-to command to start ACLs to identify traffics and perform traffic mirroring for packets that
match.
Use the undo mirrored-to command to remove traffic mirroring configuration.
mirroring-group
Use the mirroring-group command to configure a mirroring group.
Use the undo mirroring-group command to delete a mirroring group.
mirroring-group mirroring-port
Use the mirroring-group mirroring-port command to configure the source port.
Use the undo mirroring-group mirroring-port command to remove the configuration of the source
port.
mirroring-group mirroring-slot
Use the mirroring-group mirroring-slot command to configure the mirroring source I/O Module.
Use the undo mirroring-group mirroring-slot command to remove the mirroring source I/O Module.
mirroring-group monitor-port
Use the mirroring-group monitor-port command to configure the destination port.
Use the undo mirroring-group monitor-port to remove the configuration of the destination port.
3Com Switch 7750 Family
Quick Reference Guide
System view
IS-IS view
Ethernet port view
System view
System view
System view
ISP domain view
QoS view
System view
System view/Ethernet port view
System view
System view/Ethernet port view