Huawei NE40E-X1 Hardware Description page 52

HUAWEI NE40E-X1 & NE40E-X2 Universal Service
Router
Hardware Description
Table 3-1 Functions of the indicators on the 8-Port 100/1000Base-X-SFP High-speed Interface
Card (HIC)
Indicator
STAT
LINK/ACT
(green)
Interface Attributes
Table 3-2
Interface Card (HIC).
Table 3-2 Attributes of the interfaces on the 8-Port 100/1000Base-X-SFP High-speed Interface
Card (HIC)
Attribute
Connector
Interface attributes Determined by the selected SFP optical module
Working mode
Standard
compliance
Frame format
Network protocol
Table 3-3 Attributes of the 100 M SFP optical module
Attribute
Maximum
transmission
distance
Center wavelength
Issue 02 (2011-09-10)
Description
If the indicator is steady green, it indicates that the FPIC works normally.
If the indicator is off, it indicates that the FPIC is powered off or is not
registered.
If the indicator is steady red, it indicates that the hardware on the FPIC
is faulty.
If the indicator is steady yellow, it indicates that the FPIC is installed in
a slot for a HIC and an alarm is reported or the FPIC is not loaded with
the logic.
If the indicator is steady on, it indicates that the link is normal.
If the indicator blinks, it indicates that data is being transmitted.
If the indicator is off, it indicates that the link is Down.
lists the attributes of the interfaces on the 8-Port 100/1000Base-X-SFP High-speed
Value
LC/PC
Full-duplex
IEEE 802.3-2002
Ethernet_II, Ethernet_SAP, and Ethernet_SNAP
IP
Value
2 km ( 1.24
mi. )
1310 nm
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
15 km ( 9.32 40 km ( 24.86
mi. ) mi. )
1310 nm 1310 nm
3 Boards
80 km ( 49.71
mi. )
1550 nm
44