Brief Description Of The Unit - Komfovent DOMEKT Series Installation And Service Manual

When unit is loaded or unloaded by crane, cargo rope is fastened in its designated places.
Forklift truck or hand pallet truck can transport air handling unit as it is shown (2 a, b, c Pictures).
Vertical and horizontal unit transportation by forklift truck, hand pallet truck or crane
2a Picture
2a Unit is transported by forklift truck on a wooden pallet;
2b Unit is transported by hand pallet truck on a wooden pallet;
2c Unit is lifted by crane on a wooden pallet.
The unit should be examined upon receipt, to ensure that no visible damage has occurred during
transit, and the advice note checked to ensure that all items have been received. If damage or delivery
shortages are disco vered, the carrier should be immediately informed. KOMFOVENT should be notified
within three days of receipt, with a written confirmation sent within seven days. KOMFOVENT can accept
no responsibility for damage by unloading from carrier or for subsequent damage on site.
If the unit is not to be installed immediately, it should be stored in a clean, dry area. If stored exter-
nally, it should be adequately protected from the weather.

3. BRIEF DESCRIPTION OF THE UNIT

• The air handling units are intended for ventilation of small and medium-sized spaces (eg. single
family houses, offices, etc.), having operating ambient temperature and relative humidity. The unit
is intended to be installed in the domestic or non residential premises. Mineral wool is used for
thermal insulation and sound attenuation. Units cover panels are 25–50 mm thick. As standard, the
unit is designed for indoor placement. In cold, wet rooms possible icing or condensation on the
housing inside and outside. The operating temperature range for the unit is -30 °C ... +40 °C, outdoor
air temperature. Extracted indoor air temperature +10 – +40 °C, relative humidity (non-condensing)
20–80 %.
• The air handling unit is not to be used to transport solid particles, even not in areas where there is a
risk of explosive gases.
• Inside of the air handling unit it is integrated heat-exchanger and heater (or cooler), which compen-
sates losses of the heat/cold during ventilation of the premises, thus AHU is not recommended to
be used as main heating/cooling source of the building. AHU may not reach the supply temperature
setpoint if the actual room temperature differs a lot from the desired value, since in that case heat
exchanger capacity will be low.
UAB KOMFOVENT we reserve the right to make changes without prior notice
D_21-03
2b Picture
2c Picture
5