Safety Requirements; Transportation - Komfovent DOMEKT Series Installation And Service Manual

EN

1. SAFETY REQUIREMENTS

• To avoid accidents and/or unit damage, only a trained technician must carry out
the connection.
• The appropriate Personal Protective Equipment (PPE) attire is worn relative to the
operation being carried out.
• Electrical equipment is rated, connected and earthed in accordance with CE regu-
lations.
The air handling unit must be plugged in to an electrical outlet (with earth), which is in good order
and corresponds with all requirements of electric safety. Before starting any operations inside the unit,
make sure that the unit is switched off, and the power cable is unplugged.
• Earth must be installed according EN61557, BS 7671.
• The unit should be installed according to Installation and Maintenance Manual.
• Before starting the unit, check correct position of air filters.
• Service maintenance should be carried out only in conformity with the
instructions specified herein below.
• If main cable is damaged, only manufacturer, service team or trained technician
must change it in order to avoid accidents.
• Drilling and using self-tapping screws on the unit casing is prohibited (where it is
not provided by the construction), since cables or tubes inside of the casing may
be damaged.

2. TRANSPORTATION

The air handling units are ready for transit and storage (1 Picture). The unit is packed to prevent dam-
age of the external and internal parts of the unit, dust and moisture penetration.
Corners of the air handling units are protected against the damage – protective corners are used.
The entire unit is wrapped up in protective film. For transit or storage, units are mounted on timber pal-
lets. The unit is fastened to the pallet with polypropylene packing tape over protective corners.
1 Picture
4
Vertical and horizontal units ready for transit and storage
UAB KOMFOVENT we reserve the right to make changes without prior notice
D_21-03