Blue Clean Take-Along Assembly, Care And Use Instructions page 11

1900 psi electric pressure washer
Table of Contents

Advertisement

OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
• When removing the detergent tank, squeeze the
clamp and remove the small hose from detergent
tank. Pull the detergent tank straight out. To replace
tank, push straight in and then reattach hose with
clamp.
• When using the onboard detergent tank you need to
use the black "SOAP" nozzle. The low pressure of this
nozzle activates the detergent suction. The suction
WILL NOT WORK with any other of the included
nozzles.
Adjusting Soap Levels on Foam Cannon
Twist knob to adjust the level of soap as indicated on
the top of the foam cannon (M). Twist toward the higher
concentration of bubbles for more soap, or the opposite
direction for less.
94630_Take-Along_1900PSI_IM_EN.indd 11
• The power washer will pull a ratio of water to
Operation Tips
• If you hear the motor run intermittently when the
• Keep the nozzle cleaning wire for use in unclogging
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs because
Never use a narrow high pressure stream of water on
soft surfaces susceptible to damage.
• Use the 25˚ angle quick connect nozzle when
H
M
detergent of 10:1 or 10 parts water to 1 part
detergent. The detergent concentration can be
adjusted by turning the detergent knob on the top of
the cannon. Turn it left for more concentration or turn
it right for less concentration.
trigger is not being squeezed, that is normal. The
pump is priming itself so it is ready to operate when
the trigger is squeezed. Turn off the power washer if
not being used after five minutes.
the lance nozzle. If you lose the cleaning wire, a
straightened paper clip also works.
the impact force of the water pressure exceeds
the durability of the surface. Bare wood can be
penetrated; paint can be peeled off, etc. You can vary
the force of your power washer by controlling:
1. The angle of the surface being cleaned.
2. The distance of the nozzle from the surface being
cleaned.
cleaning windows. Be sure to place the nozzle
approximately four to five feet away from the window
with the nozzle at forty five degree angle. Squeeze
the trigger and vary the spray pattern and angle until
optimum cleaning efficiency is achieved.
11
17/11/22 下午3:43

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Take-Along and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Table of Contents