Operating Instructions - Blue Clean Take-Along Assembly, Care And Use Instructions

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS
• Make sure the "ON/OFF" switch is in the "OFF"
position. The power switch has international symbols
for 'on' and 'off': On (|) Off (O).
• Unwind the power cord completely and plug the GFCI
into a grounded 120 volt outlet.
• Turn on water supply at the faucet to completely open.
• Release safety by twisting trigger lock. While pointing
the spray gun in a safe direction, squeeze the trigger
on the spray gun until there is a steady stream of
water, letting the water and air out of the hose. Twist
trigger lock back into locking position.
• Turn the power switch to the "ON" (|) position. The
unit will turn on for 1 - 2 seconds and shut off. This is
a normal function of the auto start feature.
• Begin power washing by squeezing the trigger on the
spray gun all the way into the handle.
• Release the spray gun trigger to stop the power
washer.
• Allow the motor to come to a complete stop before
squeezing the trigger again.
• Squeezing rapidly will cause the auto start feature to
miss an on/off cycle that may prevent it from turning
on while squeezing trigger after rapid squeezing. Use
slow deliberate trigger pulls to avoid such symptoms.
OFF/0
ON/I
10
94630_Take-Along_1900PSI_IM_EN.indd 10
OFF/0
ON/I
Always test a small area to avoid chance of damaging
the surface.
The power washer unit also can be stored uprightly.
• When using detergent (not included), fill the
detergent tank with a properly formulated detergent
or cleaner with water ratio according to instructions
on the container. Close detergent tank when done
filling.
17/11/22 下午3:42