Removing The Unit - Kenwood KDC-PS9060R Instruction Manual

Removing the Unit

Removing the hard rubber frame
1
Insert the removal tool5 deeply with the cut placed to the
right to remove the upper locks at an angle as shown below.
Lock
Cut
Accessory5
Removal tool
2
Engage the catches on the removal tool2 and remove the two
locks on the lower level, leaving the removal tool5 inserted on
the upper level.
Use the removal tool facing the side covered with the
protective sheet to the faceplate.
Lower the frame and pull it forward as shown in the figure.
Accessory2
Removal tool
NOTE
You will feel (not hear) a click when the tabs lock securely.
1
2
3
4
Catch
Lock
5
— 40 —
Removing the Unit
Refer to the section "Removing the hard rubber frame" and
then remove the hard rubber frame.
Remove the hex head machine screw with washer (M4 8) on
the back panel.
Insert the two removal tools at an angle and push them deeply
into the slots on each side, as shown.
Accessory3
Push downward on the left-
hand tool and the upward
on the right-hand tool, as
shown, and pull the unit
toward you until it is
halfway out. The unit may
drop if you pull it out
completely.
2CAUTION
Be careful to avoid injury from the catch pins on the removal tool.
Pull the unit all the way out
with your hands, being
careful not to drop it.
Accessory2
Removal tool