Connecting Cables To Terminals - Kenwood KDC-PS9060R Instruction Manual

Connecting Cables to Terminals

Connector Function Guide
Pin Numbers for
Cable Colour
ISO Connectors
External Power
Connector
A–4 Yellow
A–5 Blue/White
A–6 Orange/White
A–7 Red
A–8 Black
Speaker
Connector
B–1 Purple
B–2 Purple/Black
B–3 Gray
B–4 Gray/Black
B–5 White
B–6 White/Black
B–7 Green
B–8 Green/Black
Battery cable (Yellow)
Ignition cable (Red)
A–7
A–4
FM/AM antenna input
Functions
Battery
Power Control
Dimmer
Ignition (ACC)
Earth (Ground)
Connection
+
Rear Right ( )
–
Rear Right ( )
+
Front Right ( )
–
Front Right ( )
+
Front Left ( )
–
Front Left ( )
+
Rear Left ( )
–
Rear Left ( )
Pin (Red)
Pin (Yellow)
Connector A
Connector B
Antenna Conversion Adaptor (ISO–JASO) (Accessory4)
Antenna Cord (ISO)
KENWOOD disc changer/DAB control input
NOTE
Fuse
To connect the Disc changer or DAB unit,
consult each manual.
Wiring harness
(Accessory1)
TEL MUTE
TEL mute cable (Brown)
P.CONT.OUT
Power control/ Motor antenna
control cable (Blue/White)
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
— 38 —
Front right output (Red)/
Non-fading right output (Red) (KDC-PS9060R only)
Front left output (White)/
Non-fading left output (White) (KDC-PS9060R only)
Rear right output (Red)
Rear left output (White)
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
NOTE
To connect the KENWOOD navigation
system, consult your navigation manual.
NOTE
If no connections are
made, do not let the cable
come out from the tab.
Connect either to the power control terminal
when using the optional power amplifier, or to
the antenna control terminal in the vehicle.