Installation - Kenwood KDC-PS9060R Instruction Manual

2WARNING
Connecting the ISO Connector (see p.38)
The pin arrangement for the ISO connectors depends on the type
of vehicle you drive. Make sure to make the proper connections to
prevent damage to the unit.
The default connection for the wiring harness is described in 1
below. If the ISO connector pins are set as described in 2 or 3,
make the connection as illustrated.
1 (Default setting) The A-7 pin (red) of the vehicle's ISO
connector is linked with the ignition, and the A-4 pin (yellow) is
connected to the constant power supply.
Unit
Ignition cable (Red)
Battery cable (Yellow)
2 The A-7 pin (red) of the vehicle's ISO connector is connected to
the constant power supply, and the A-4 pin (yellow) is linked to
the ignition.
Unit
Ignition cable (Red)
Battery cable (Yellow)
3 The A-7 pin (red) of the vehicle's ISO connector is not
connected to anything, whilst the A-4 pin (yellow) is connected
to the constant power supply (or both the A-7 (red) and A-4
(yellow) pins are connected to the constant power supply).
Unit
Connect to a power source that can be
Ignition cable (Red)
turned on and off with the ignition key.
Battery cable (Yellow)
Installtion

Installation

Accessory3
Vehicle
A–7 Pin (Red)
A–4 Pin (Yellow)
Self-tapping
screw
(commercially
available)
Vehicle
NOTE
A–7 Pin (Red)
Make sure that the unit is installed securely in place. If the unit is
unstable, it may malfunction (eg, the sound may skip).
A–4 Pin (Yellow)
Vehicle
2CAUTION
To attach this unit, fit it into the mounting sleeve by pressing the four
A–4 Pin (Yellow)
corners of the hard rubber frame.
Do not apply strong pressure to other sections than the corners;
otherwise troubles such as the impossibility of opening or closing the
panel may result.
— 39 —
Firewall or metal support
Metal mounting
strap
(commercially
available)
Bend the tabs of the
mounting sleeve with
a screwdriver or
similar utensil and
attach it in place.