Data Report; R718E To Report Three-Axis Acceleration And Velocity - netvox R718E User Manual

Wireless three-axis digital accelerometer & ntc thermistor

Hide thumbs Also See for R718E:

User manual (14 pages)

User manual (8 pages)

Table Of Contents

Table of Contents

Sleeping Mode

The device is on and in the

Sleeping period: Min Interval.

network

When the reportchange exceeds setting value or the state changes: send a data report according to Min Interval.

First two mins: wake up every 15 seconds to send request.

The device is on but not in

After two mins: enter sleeping mode and wake up every 15 minutes to send request.

the network

Note: Suggest to remove batteries if the device is not used.

Low Voltage Warning

Low Voltage

3.2V

5. Data Report

When the device is turned on, it will immediately send a version package and a cluster report data.

Data will be reported once per hour by default setting.

Maximum time: 3600s

Minimum time: 3600s (Detect the current voltage value every 3600s by default setting)

Default reportchange:

Batteryvoltagechange ---- 0x01(0.1V)

Acceleratedvelocitychange ---- 0x03(m/s²)

Remarks:

1. The device data sending cycle depends on the burning configuration before shipment.

2. The interval between two reports must be the minimum time.

5.1 R718E to report three-axis acceleration and velocity

R718E will report immediately when it detects vibration that exceeds the Active Threshold.

The next detection/report will not be ready until the the vibration has been stopped for at least 5 seconds. If vibration happens during this 5-second

period, the period will restart.

* The 5-second period cannot be modified.

R718 sends two packets. One is the three-axis acceleration value, and the other is the three-axis velocity and temperature. The interval between these

two packets will be 10 seconds.

Note: MinInterval is the sampling period for the Sensor. Sampling period >= MinInterval.

The reported data is decoded by the Netvox LoRaWAN Application Command document and

Data report configuration and sending period are as following:

Description

Device

ConfigReportReq

ConfigReportRsp

R718E

ReadConfig

ReportReq

ReadConfig