Operation Of Remote Control Unit - Kenwood R-SG7 Instruction Manual

Operation of remote control unit

Loading batteries
1 Remove the cover.
Operation
After plugging the power cord of this unit, press
the (on/standby) key of the remote control
unit to turn the power of the system ON. When
the power is turned ON, press the key of the
function to be operated.
÷ When pressing more than one remote control keys
successively, press the keys securely by leaving an
interval of 1 second or more between keys.
1.The provided batteries are intended for use in operation checking, and their service life may be short.
2.When the remote controllable distance becomes short, replace both of the batteries with new ones.
Notes Notes Notes
3.If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote
sensor, malfunction may occur. In such a case, change the installation position to avoid malfunction.
2 Insert batteries.
÷ Insert two R6 ("AA"-size) batteries following the polarity indications.
Operating range (approx.)
Model: RC-R0713E
Infrared ray system
Operation of remote control unit
R-SG7/DP-SG7/X-SG7 (EN)
3 Close the cover.
6 m
30° 30°
17
Remote
sensor