Basic Operation Of Remote Control Unit - Kenwood Sovereign VR-5080 Connection And Setup Manual

Chapter Two : Setting Up the Remote Control Unit
Remote Control unit is a new type of Remote Control unit
which receives information from the receiver and display it
on the LCD screen.
This section describes the basic operations of Remote Con-
trol unit.
Turning power on:
To turn the receiver on: Press the SYS.POWER button.
To turn the connected device on: Press the AV POWER but-
ton.
(It is necessary to perform the procedure in "Identifying
Components for Remote Control Unit" on page 39 to en-
able remote control of AV devices.)
Selecting the input:
Audio device: Press the button repeatedly. The in-
MUSIC
put names where audio devices are identi-
fied by Remote Control unit will be shown
on the LCD screen.
1CD1 :
2MD/Tape1 :
3Tuner :
4CD-R :
5Phono :
If an audio device which is connected to an
input is not identified by Remote Control
unit, the device name is skipped and not dis-
played.
Video device: Press the button repeatedly. The input
MOVIE
names where video devices are identified by
Remote Control unit will be shown on the
LCD screen.
1Video1 :
2Video2 :
3Video3 :
4Video4 :
5DVD/6ch :
6AV AUX :

Basic Operation of Remote Control Unit

If a video device which is connected to an in-
put is not identified by Remote Control unit,
the device name is skipped and not displayed.
(VR-5080 only)
Although Video4 is displayed in the initial
status, the receiver cannot be switched to se-
lect Video4. The Video4 display will not ap-
pear after the Remote Control unit has been
set up.
TV: Press the button. The LCD screen shows TV if
TV
this is registered in and identified by Remote Control
unit.
Adjusting the receiver's volume:
Press the VOL. (+/-) button until the de-
sired volume is obtained.
Muting audio temporarily:
Press the MUTE button.
To resume the original volume, press the MUTE button again
or press one of the VOL. (+/-) buttons.
Using the numeric buttons:
When entering a figure directly for selecting a CD track num-
ber, etc., press the numeric buttons as shown below.
To enter 5 :
To enter 25 :
or
:
2
The button to be pressed varies depending on the
function.
Screen menu control operation
2WAY LCD REMOTE CONTROL UNIT
+
VOL.
LCD
Function
Function
VOL.
-
button 1
button 2
The contents of the func-
tion buttons vary according
to current situations, and
the function names (Next,
Back, Enter, etc.) are shown
on the screen.
For details, see the descrip-
tion of each control opera-
tion.
REC REC
LCD
35
Press to select an item by
scrolling the screen menu
up or down.
The selected item is dis-
played in an inverted color.