Winnebago FORZA Series Manual page 52

SECTION 4 –
APPLIANCES AND SYSTEMS
(Latch shown in unlock position)
-Typical View
Basic Refrigerator Operation
Temperature controls are factory preset for
your convenience. When you first use your
refrigerator, make sure the controls are still set to
the recommended setting as shown.
Recommended setting is "Mid-setting 3"
See the manufacturer's user guide provided in
your InfoCase for information on adjusting
refrigerator/freezer temperatures to best suit your
needs.
NOTE: Allow 24 hours for your refrigerator to
cool completely before storing food.
Ice Maker Operation
• To turn the ice maker on, lower the wire shut-
off arm.
NOTE: Do not force the wire shut-off arm up or
down.
• To manually turn the ice maker off, lift the
wire shut-off arm to the OFF (arm up) position
until it clicks.
4-2
NOTE: Your ice maker is equipped with an
automatic shutoff. As ice cubes fill the
storage bin, the wire arm is raised to the
OFF (arm up position).
Further Information
Refer to the manufacturer's user guide
provided in your InfoCase for complete operating
instructions, safety precautions, and maintenance
information.
REFRIGERATOR –
RESIDENTIAL
–If Equipped
Your motorhome may be equipped with a
"residential style" refrigerator. This refrigerator
operates off of the 120-volt electrical system in
your motorhome.
In order to operate, the refrigerator requires
either the shoreline to be plugged in, the
generator running, or inverter power.
The inverter is intended to power your 120
volt residential refrigerator primarily when
driving your vehicle. The house batteries will
drain quickly if the refrigerator is powered from
the inverter when the engine is not running. Other
120 volt appliances and other 120 volt devices
are not intended to operate with inverter power
for long periods of time as they too will quickly
drain your house batteries.
NOTE: The refrigerator operates off of 120-volt
power. When power is off, the ice maker
drain valve (located behind sidewall
access compartment) needs to be in the
ON position. This will ensure that water
does not discharge from the water
dispenser when power is reconnected to
the appliance.